|
PV500 Vacuum Specifications |
|
| Air Consumption | 500 C.F.M @ 100 P.S.I |
| Vacuum Loading rate | 58.7 S.C.F.M @ 25 “ H.G |
| Control Power (batteries) | 12 Volt D.C |
| Operator Controls (Man/Auto Vacuum/Discharge) | 2 Toggle switches/Timer |
| Height | 60” |
| Width | 42” |
| Length | 60” |
| Vacuum Inlet | 4” Cam Lock |
| Discharge Outlet | 4” Victaulic |
| Air Inlet | 2” N.P.T |
| Pressure Vessel | Certified |
| Weight | 1200 LBS |
| Skid Mounted c/w forklift lift points | |
| The PV500 Vacuum unit cycles from vacuum to discharge when the pressure vessel is filled with the material being vacuumed. This is set by the operator on a timer located in the control box. Overfilling will not damage the unit. | |
| Material being vacuumed does not come in contact with any moving parts. | |
| Handles wet or dry material, sludges, slurries, sand, gravel, and rock | |
| Batteries are good for approximately one-month continuous operation before recharge. | |
| Virtually maintenance free as there are only three moving parts (knife gate valves) | |
| There are no filters to clean or replace. | |